Mounting The Cover For The 500 V Ac Infeed Bus - Siemens SIMATIC ET 200SP System Manual

4.3

Mounting the cover for the 500 V AC infeed bus

Introduction
The 500 V infeed bus connects all SIMATIC ET 200SP motor starters. For finger-safe
termination of the infeed bus, you must use the cover.
Procedure
To mount the infeed bus cover on a SIMATIC ET 200SP motor starter module, proceed as
follows:
1. Press the cover onto the opening of the BaseUnit on the right until it audibly engages.
The cover can be removed again using 2 fingers and without tools.
Personal injury may occur
On the last plugged-in BaseUnit of a SIMATIC ET 200SP motor starter in an ET 200SP
system, you must place a cover on the opening of the contacts of the infeed bus.
Motor starter
System Manual, 04/2016, A5E35582704002A/RS-AA/001
WARNING
4.3 Mounting the cover for the 500 V AC infeed bus
Mounting
41