Status Messages - Polycom HDX 9006 Integrator's Manual

Status Messages

Status Display
The call status can be displayed in a number of ways. The "getcallstate" on page 272 returns a table listing
the status, speed, and dialed number of current calls.
To display real-time status on individual B channels (incoming or outgoing calls), either register the API
session with the callstate
page 203. These two commands will cause the system to re-direct the B channel status messages to the
session which has issued one of these two commands. For example, if the RS-232 device issues a dial
command, then call status is directed to the RS-232 port; if a later session on a Telnet port issues a dial
command, then call status is also directed to that Telnet port.
B Channel Status Message Example
The following output example is for B channel status messages, where:
Polycom, Inc.
command on page 171, or start an outbound call with the
cs Indicates call status for one B channel.
RINGING Indicates a ring-in or ring-out and is equivalent to a 25% blue
sphere on the graphical user interface.
CONNECTED Is equivalent to a 50% yellow sphere.
BONDING Indicates the bonding protocol is operational on the channel and
is equivalent to a 75% orange sphere.
COMPLETE Is equivalent to a 100% green sphere.
dial command on
582