Table of Contents
Advertisement
Integrator's Reference Manual for Polycom HDX Systems
pricallbycall
Sets or gets the PRI call-by-call value. This command is only applicable if you have a PRI network interface
connected to your system.
Syntax
pricallbycall get
pricallbycall set {0..31}
Parameter
get
set
{0..31}
Feedback Examples
● pricallbycall set 1
returns
pricallbycall 1
● pricallbycall get
returns
pricallbycall 1
Comments
Call-by-call is a number from 0 to 31, which is optionally sent to an upstream telephone company switch, if
required. For example, specify a value of 6 for a T1 PRI network interface module that is directly connected
to an ATT 5ESS switch, which is provisioned with Accunet. You must consult with the telephone company
service provider to determine whether a call-by-call value is required for a particular PRI line. For most
cases, the default value of 0 is correct. Always use the value 0 when connected to a PBX. A non-zero value
should not be required in Europe. Values greater than 31 are reserved for internal use and must not be used.
Polycom, Inc.
Description
Returns the current setting.
Sets PRI call-by-call when followed by a value from
{0..31}.
Range of call-by-call values.
System Commands
380
Advertisement
Table of Contents
