Table of Contents
Advertisement
Integrator's Reference Manual for Polycom HDX Systems
dsr
Sets or gets the configuration of the DSR serial interface control signal (data set ready). This command is
only applicable if you have a V.35 network interface connected to your system.
Syntax
dsr <get|normal|inverted>
Parameter
get
normal
inverted
Feedback Examples
● dsr normal
returns
dsr normal
● dsr inverted
returns
dsr inverted
● dsr get
returns
dsr inverted
Comments
The default setting for this signal is "normal".
Polycom, Inc.
Description
Returns the current setting.
Sets the signal to normal (high voltage is logic 1).
Sets the signal to inverted (low voltage is logic 1).
System Commands
217
Advertisement
Table of Contents
Need help?
Do you have a question about the HDX 9006 and is the answer not in the manual?
Questions and answers