Table of Contents
Advertisement
Integrator's Reference Manual for Polycom HDX Systems
v35dialingprotocol
Sets or gets the V.35 dialing protocol. This command is only applicable if you have a V.35 network interface
connected to your system.
Syntax
v35dialingprotocol <get|rs366>
Parameter
get
rs366
Feedback Examples
● v35dialingprotocol rs366
returns
v35dialingprotocol rs366
● v35dialingprotocol get
returns
v35dialingprotocol rs366
Comments
Selecting a dialing protocol is not needed if you are using your DCE to dial the call or if you have a dedicated
connection to the far site.
Polycom, Inc.
Description
Returns the current setting.
Enables RS-366 as the dialing protocol. At this time,
RS-366 is the only supported dialing protocol on the
system.
System Commands
547
Advertisement
Table of Contents
