Isdndialspeed - Polycom HDX 9006 Integrator's Manual

Integrator's Reference Manual for Polycom HDX Systems

isdndialspeed

Sets or gets the valid dialing speed of the ISDN network interface. This command only applies if an ISDN
network interface is connected to a system.
Syntax
isdndialspeed get "valid speed"
isdndialspeed set "valid speed" <on|off>
Parameter
get
set
"valid speed"
on
off
Feedback Examples
● isdndialspeed set 256 on
returns
isdndialspeed set 256 on
● isdndialspeed set 168 off
returns
isdndialspeed set 168 off
● isdndialspeed get 168
returns
isdndialspeed 168 off
Comments
The Polycom HDX system does not support separate settings for ISDN and IP dialing speeds. When you
change a setting using this command, the settings associated with the
also change, and vice versa.
Polycom, Inc.
Description
Returns the current setting. The parameter "valid
speed" is required.
Sets the ISDN dialing speed. The parameters "valid
speed" and on or off are required.
Valid speeds are: 56, 64, 2x56, 112, 2x64, 128, 168,
192, 224, 256, 280, 320, 336, 384, 392, 7x64, 504, 512,
560, 576, 616, 640, 672, 704, 728, 768, 784, 832, 840,
14x64, 952, 960, 1008, 1024, 1064, 1088, 1120, 1152,
1176, 1216, 1232, 1280, 1288, 21x64, 1400, 1408,
1456, 1472, 1512, 1536, 1568, 1600, 1624, 1664, 1680,
1728, 1792, 1856, and 1920 kbps.
Note: The highest speed for BRI systems is 512 kbps,
the highest speed for T1 systems is 1472 kbps, and the
highest speed for E1 systems is 1920 kbps.
Enables the specified speed.
Disables the specified speed.
System Commands
ipdialspeed command on page 306
318