Table of Contents
Advertisement
Integrator's Reference Manual for Polycom HDX Systems
Parameter
stop
continuous
discrete
source
getposition
setposition "x" "y"
"z"
ppcip
for-people {2..4}
for-content {2..4}
list-content
register
unregister
Polycom, Inc.
Description
Stops the near or far camera when in continuous mode.
Returns no feedback.
Selects continuous movement mode. The camera
moves in direction specified until a camera
<near|far> move stop command is sent. This is the
default setting.
Selects discrete movement mode. The camera moves a
small amount in the direction specified and then stop.
No stop command is required.
Returns the number of the near or far camera source
currently selected.
Gets the pan, tilt, and zoom coordinates of the currently
selected PTZ camera in the format of pan tilt zoom.
Sets the pan (x), tilt (y), and zoom (z) coordinates of the
currently selected PTZ camera. Camera PTZ range:
-880 <= pan <= 880
-300 <= tilt <= 300
0 <= zoom <= 1023
Notes:
The camera PTZ range applies to the Polycom
EagleEye HD camera. Different cameras might have
different PTZ values.
Some D30 cameras might not be able to reach the full
range limit. For example, although the pan limit is 880,
the camera might only be able to reach a nearby value.
Specifies People+Content IP as the main video source if
it is running and connected to the system.
Sets the source for the specified camera to People.
Sets the source for the specified camera to Content.
Gets a list of cameras configured as Content.
Registers to receive feedback when the user changes
the camera source. Returns the current camera
registration state when followed by the get parameter.
Unregisters to receive feedback when the user changes
the camera source.
System Commands
174
Advertisement
Table of Contents
