Integrator's Reference Manual for Polycom HDX Systems
isdnswitch
Sets or gets the ISDN switch protocol. This command is only applicable if you have an ISDN network
interface connected to your system.
Syntax
isdnswitch get
isdnswitch <pt-to-pt_at&t_5_ess|multipoint_at&t_5_ess|ni-1>
isdnswitch <nortel_dms-100|standard_etsi_euro-isdn|ts-031|ntt_ins-64>
Parameter
get
pt-to-pt_at&t_5_ess|
multipoint_at&t_5_es
s|
ni-1|nortel_dms-100|
standard_etsi_euro-i
sdn|ts-031|ntt_ins-6
4
Feedback Examples
● isdnswitch pt-to-pt_at&t_5_ess
returns
isdnswitch pt-to-pt_at&t_5_ess
● isdnswitch nortel_dms-100
returns
isdnswitch nortel_dms-100
● isdnswitch get
returns
isdnswitch nortel_dms-100
Comments
If more than one switch protocol is supported, you must find out from your telephone service provider which
protocol to select. If you change the country settings, a new set of ISDN switch protocols is loaded.
See Also
To set the switch type for PRI systems, use the
Polycom, Inc.
Description
Returns the current switch protocol.
Specifies the ISDN switch protocol to use.
priswitch
command on page 390.
System Commands
320