Cleaning; Technical Support - Christie CP2208 Service Manual

Cleaning

Danger! Failure to comply with the following results in serious injury.
ELECTRICAL SHOCK HAZARD! Make sure that the projector is completely powered down and
disconnected from AC before the lens or any of the projection head covers or doors are loosened and
removed. Wear gloves when handling internal components.
You must keep all internal components clean during any service procedure. In particular, all of the
projector's optics must remain free of contaminants to perform at the level specified for the
projector. Even a small amount of dust or a fingerprint can degrade the image or cause a noticeable
reduction of brightness. When you service the projector, take all necessary measures to avoid
touching or contaminating optical surfaces. Always wear gloves (provided) when you handle
internal components. Make sure that the projector is OFF and disconnected from AC before you
clean it.
If you follow the proper precautions, a minimum amount of cleaning (typically none) is required
during and after servicing.

Technical support

For immediate assistance with common problems, see Troubleshooting.
If you are unable to resolve your issue, contact Christie support. In order that a support
representative can better assist you, have the model and serial number of your projector ready. For
contact information for your region, see the back cover of this document.
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Introduction
12