Aligning The Lamp - Christie CP2208 Service Manual

If the values are outside the tolerances, check the MCGD values are correct, the channel was
created correctly, or reposition the yellow notch filter. If these corrective measures do not
work, replace the yellow notch filter. Repeat the entire procedure for each corrective action
you attempt.
9. Repeat steps 7 and 8 for the RBG-12bit-Full Screen Red, Green, and Blue test patterns.
10. Replace the yellow notch filter cover.
11. Replace the top lid.

Aligning the lamp

You must adjust the lamp position whenever you install a lamp. Before you adjust the lamp, turn
the lamp on, open the douser, and allow it to warm for a minimum of 10 minutes.
1. Tap Menu > Advanced Setup > Lamp Power.
2. Verify the value in the Power% field is at a level suitable for your requirements.
3. Tap Menu > Advanced Setup > Light Adjust.
4. Record the number in the Intensity field.
5. Tap Display Full Screen White Test Pattern.
6. Complete a coarse lamp adjustment:
a. Locate the Y axis adjustment label on the operator side of the projector.
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Adjusting the Image
23