Christie CP2208 Service Manual page 42

10. For CDXL-19SC or CDXL-21S1 lamps:
a. Loosen the cathode screw (D) on the cathode clamp (F).
b. Hold the anode end of the lamp with your left hand and then carefully unscrew and
remove the cathode nut with your right hand (E).
c. As you hold the anode end of the lamp, carefully guide the lamp through the reflector
ensuring not to make contact with the reflector.
d. With your right hand guide the cathode end out of the reflector, on an angle through the
lamp access door.
11. Open a protective lamp case and then place the old lamp into the case. Thread the cathode nut
onto the lamp, close the protective case, and then place the lamp within the case, on the floor
where it cannot fall or be bumped.
Warning! Failure to comply with the following could result in serious injury.
Handle the protective case with extreme caution - the lamp is hazardous even when
packaged. Dispose of lamp box according to local area safety regulations.
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Anode Terminal
A
Anode Wire
B
Reflector
C
Cathode Screw
D
Cathode Nut
E
Cathode Clamp
F
Parts and Module Replacement
42