Adjusting The Image; Rotating The Integrator Rod - Christie CP2208 Service Manual

Adjusting the Image

This section provides information and procedures for adjusting the projector image.

Rotating the integrator rod

Warning! Failure to comply with the following could result in serious injury.
• Never operate the projector or the fans without all the covers installed.
• UV HAZARD! When servicing the projector with the top lid removed anyone within the immediate
vicinity must wear safety glasses with side shields.
Whenever the integrator module is moved or replaced, its rotation must be corrected for proper
focus and full illumination of the three digital micromirror devices (DMDs).
1. Display a full white field test pattern:
a. On the touch panel controller (TPC), tap the Test Pattern icon (
b. Tap All Test Patterns.
c. Tap RGB-12bit-Full Screen White.
2. Remove the top lid. See
3. Put on a pair of heat resistant gloves and UV resistant glasses.
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Removing the top lid on page 33.
) in the task bar.
13