Removing The High Security Interlock Switch; Removing The Card Cage Skin - Christie CP2208 Service Manual

Removing the high security interlock switch

The Lamp Door Interlock is located at the rear of the projector and is activated when you open the
firewall door.
1. Turn the projector off and then disconnect it from AC power.
2. Remove the top lid. See
3. Remove the high security lid. See
4. Disconnect the red and black leads from the switch.
5. Remove the two nuts securing the switch to the frame and then remove the interlock switch.

Removing the card cage skin

This card cage skin should never need to be removed unless it is damaged and requires
replacement. From the rear of the projector, the card cage skin is on the right-side of the projector.
1. Turn the projector off and then disconnect it from AC power.
2. Remove the top lid. See
3. Remove the two screws from above the card cage.
4. Remove the card cage. See
5. Remove the four screws that secure the skin to the corner brackets.
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Removing the top lid
Removing the high security and light engine lid
Removing the top lid
Removing the card cage
Parts and Module Replacement
.
on page 33
on page 33.
on page 54.
.
on page 35
36