Christie CP2208 Service Manual page 21

Field
Target Color
Color Space
Gamma
LUT_CLUT
Scan Type
Automatic Scan Type
Detection
Use PCT
PCT File
g. Tap 3D Control in the left pane if the channel will be used to display 3D content.
Complete these fields:
Field
Enable 3D
3D Test Patterns
3D Sync Input Mode
L/R Display Reference
Frame Rate N:M
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Description
The Target Color Gamut Data (TCGD) value. Select Color Verification.
The method of color decoding for the current source. The default is YCbCr
for all DVI sources. The default for all cinema sources is Unity RGB. This
option is not available when Use PCF is selected.
The gamma correction required for the proper tonal range of the source
material.This option is not available when Use PCF is selected.
Applies a 3D color cube for increased color accuracy. This option is not
available when Use PCF is selected.
The video scan type. The default is Progressive.
Automatically performs scan type detection. This feature is supported for
PIBS1 inputs only.
Applies Christie Pureformity Color Technology (PCT) to the channel.
Identifies the Christie Pureformity Color Technology (PCT) file associated
with the channel.
Description
Enables 3D.
Displays 3D test patterns.
Specifies whether a specific frame of input data has left eye or right eye
data.
Select Use White Line Code (true and inverted) if you are using a single
3D input signal in which an embedded white line at the bottom of each
frame identifies left and right, and an additional separate 3D stereo
sync input at the GPIO port is not present. The bottom row of the left-
eye sub-field should be pure white for the left-most 25% of the pixel
row and pure black for the remainder of the row. The bottom row of the
right-eye sub-field should be pure white for the left-most 75% of the
pixel row and pure black for the remainder of the row.
Select Use Line Interleave for 3D source data only. When specified, the
ICP will de-interleave each line into the left image or right image in
memory as specified. Line interleave can be used with PsF 3D data (left
and right data for one field, then left and right data for second field).
Specifies which frame of eye data to display during a specific display
frame. This signal is referenced to the display frame rate which is
specified by the Frame Rate N:M.
Sets how many frames to display per number of frames that form one
complete image. Increase the display frame rate to reduce flicker from
your source(s).
Adjusting the Image
21