Christie CP2208 Service Manual page 22

Field
L/R Display Sequence
3D Sync Polarity
Dark Time
Output Delay
Phase Delay
h. Tap Activate to activate the channel.
7. Display a RGB-12bit-Full Screen White test pattern:
a. On the touch panel controller (TPC), tap the Test Pattern icon (
b. Tap All Test Patterns.
c. Tap RBG-12bit-Full Screen White.
8. Measure the color point of the pattern with the spectroradiometer and verify that the values are
within these tolerances:
Color
Red
Green
Blue
White
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Description
Defines the frame order (L-R or R-L) required for 3D perspective. This
option only has meaning when the Frame Rate factor M is equal to 2.
For this case, 2 input frames of data are required to constitute a
complete frame of image data. This parameter tells the system which
frames go together to make a complete image. When using Line
Interleave as the 3D Sync Input Mode, ensure that Left (L1R1
L2R2) is selected.
Keeps 3D stereo sync output the same as input (true) or reversed
(inverted).
True: 3D L/R sync output from GPO will match L/R sync input.
Inverted: 3D L/R sync output from GPO will be the opposite of sync
input (left = right, right = left).
Creates a blank time interval between left and right frames to allow for
LCD shutter glasses, Z screen, or rotating 3D wheel to synchronize the
output. See Dark Time and Output Delay below. Values between 0 and
65535 are accepted. Tap the Launch Dialog button
dark time value.
The non-image time in Microseconds (μ). Offset 3D stereo sync output
in relation to dark time interval. Acceptable values are between -32768
and 32767 are accepted where a positive offset = delay and negative
offset = start early. Tap Launch Dialog to enter the output delay
value.
The degree of reference between the left and right sync output. Values
between -180 and 180 are accepted. Tap Launch Dialog to enter the
phase delay value.
X Tolerance
0.640 +/- 0.002
0.280 +/- 0.002
0.160 +/- 0.002
0.314 +/- 0.002
Y Tolerance
0.320 +/- 0.002
0.640 +/- 0.002
0.100 +/- 0.002
0.351 +/- 0.002
Adjusting the Image
to enter the
) in the task bar.
22