Cleaning A Washable Filter - Christie CP2208 Service Manual

4. Push the clips on the top of the service panel down and out to remove the service panel.
5. Loosen the two captive screws on the cap plate and then remove it.
6. Slide the air filter out and inspect it.
If the filter appears dirty and you cannot see through it, replace it with a new paper filter, or
clean it if it is a washable filter. See
If the filter appears clean, continue to step 7.
7. Replace the air filter with the airflow indicator facing toward the projector.
8. Install the cap plate and tighten the two captive screws.
9. Install the service panel and then tighten the two screws.
10. Install the top lid.

Cleaning a washable filter

• Use only high efficiency Christie approved filters. Never operate the projector without the
filter installed.
• Use of any other part other than the ones specified by the manufacturer can result in fire,
electric shock or risk of personal injury and irreparable equipment damage.
• The installation of a filter that has not been allowed to dry completely can cause an
electrical short and damage the projector.
Washable filters (P/N 003-004654-XX Replacement Light Engine Washable Air Filter and P/N 003-
004655-XX Replacement Card Cage Washable Air Filter) can be air cleaned or washed.
For filter removal, see
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Cleaning a washable filter
Inspecting the card cage filter
Parts and Module Replacement
on page 32.
on page 30, and Inspecting the light engine
32