220V Ac Line Filter; Card Cage And Lvps Compartment; Removing The Card Cage - Christie CP2208 Service Manual

220V AC Line filter

Warning! Failure to comply with the following could result in serious injury.
UV HAZARD! Always wear protective safety clothing and a face shield when performing service with
the safety shield removed and a lamp installed.
1. Turn the projector off and then disconnect it from AC power.
2. Remove the lamp. See
3. Remove the side and rear projector skins. See
and Removing the rear skin
4. Remove the two screws that secure the AC line filter to the bracket.
5. Disconnect the two harnesses from the 220V AC line filter.

Card cage and LVPS compartment

Only Christie authorized service technicians should open the high security lid or access the
electronics inside the card cage.

Removing the card cage

The card cage module consists of the PIBS1, ICP, and Backplane.
1. Turn the projector off and then disconnect it from AC power.
2. Remove the top lid. See
3. Remove the high security lid. See
4. Remove the light engine blower. See
5. Reach into the top of the projector and disconnect the three light engine harnesses and the
backplane harness.
6. Remove the five screws that secure the card cage.
7. Remove the fire alarm interlock jumper.
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Removing the existing lamp
on page 37.
Removing the top lid
Removing the high security and light engine lid
Removing the light engine blower (fan 3)
Parts and Module Replacement
on page 40.
Removing the exhaust panel skin
on page 33.
on page 39
on page 35.
on page 58.
54