10. Attach the handle (A) included with the service assembly to the light engine (B).
11. Loosen the three captive screws securing the light engine to the light tube with a 3 mm hex
key.
12. Remove the light engine from the projector.
13. Remove the two screws securing the douser bracket to the new light engine and then remove
the douser.
14. Cover the light engine with an electro-static protective cover.
Replacing the douser assembly
The douser is attached to the light engine prism. It can be removed on its own, or with the light
engine.
1. Turn the projector off and then disconnect it from AC power.
2. Remove the top lid. See
3. Remove the high security lid. See
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Removing the top lid
Removing the high security and light engine lid
Parts and Module Replacement
on page 33.
on page 35.
51