Removing The Lens - Christie CP2208 Service Manual

6. Align the ring terminal on the anode wire with the mounting position ensuring the crimped side
of the wire is facing out. Tighten the anode screw. Route anode lead away from nearby metal
surfaces.
7. Close the lamp access door and tighten the two thumbscrews.
8. Close the firewall door and tighten the two thumbscrews.
9. Close and lock the rear access door. Ensure the hex key is placed back into its holder before
closing the rear access door.
10. Connect the projector to AC power and then turn the projector on.
11. Tap Menu > Advanced Setup > Lamp Change Wizard.
12. Tap Next.
13. Complete these fields:
Field
Type
Serial Number
Reason for Change
Lamp Expiry (Hours)
Hours Used
14. Tap Save.
15. Tap Next.
16. Align the lamp. See

Removing the lens

1. Tap and hold the red power button
projector off.
2. Allow the lamp to cool for a minimum of 15 minutes.
3. Disconnect the projector from AC power or turn the circuit breaker off.
4. Remove the lens surround.
5. Install the lens cap and turn the lens clamp to the open position with a hex key.
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Description
The lamp type.
The lamp serial number.
The reason the lamp was changed.
The number of hours the lamp can operate before replacement.
This field is auto-populated.
The number of hours the lamp has operated before installation.
Aligning the lamp on page 23.
Parts and Module Replacement
on the TPC Main panel to turn the lamp and
44