Cisco Nexus 5600 Series Reference page 252

ip msdp mesh-group
ip msdp mesh-group
To configure a Multicast Source Discovery Protocol (MSDP) mesh group with a peer, use the ip msdp
mesh-group command. To remove the peer from one or all mesh groups, use the no form of this
command.
Syntax Description
peer-address
name
Command Default
None
Command Modes
Global configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
6.0(2)N1(1)
Usage Guidelines
This command requires the LAN Base Services license.
Examples
This example shows how to configure a mesh group with a peer:
switch(config)# ip msdp mesh-group 192.168.1.10 my_admin_mesh
This example shows how to remove a peer from a mesh group:
switch(config)# no ip msdp mesh-group 192.168.1.10 my_admin_mesh
Related Commands Command
show ip msdp
mesh-group
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
248
ip msdp mesh-group peer-address name
no ip msdp mesh-group peer-address [name]
IP address of an MSDP peer in a mesh group.
Name of a mesh group.
Modification
This command was introduced.
Description
Displays information about MSDP mesh groups.
Chapter I Commands
OL-31626-01