Cisco Nexus 5600 Series Reference page 362

ip pim spt-threshold infinity
ip pim spt-threshold infinity
To create the IPv4 Protocol Independent Multicast (PIM) (*, G) state only (where no source state is
created), use the ip pim spt-threshold infinity command. To remove the creation of the shared tree state
only, use the no form of this command.
Syntax Description
route-map-name Route-map policy name that defines the group prefixes where this feature is applied.
Command Default
None
Command Modes
Global configuration mode
VRF configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
7.0(0)N1(1)
Usage Guidelines
You can specify up to 500 sequence lines in a route map.
The match ip multicast command is the only match command that is evaluated in the route map. You
can specify the group prefix to filter messages with the match ip multicast command.
You must have enabled PIM before you can use the ip pim spt-threshold infinity command.
Note
This command is not supported for virtual port channels (vPC/vPC+).
This command requires the Enterprise Services license.
Note
The ip pim use-shared-tree-only group-list command performs the same function as the ip pim
spt-threshold infinity group-list command. You can choose to use either command to implement this
task.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
358
ip pim spt-threshold infinity group-list route-map-name
no ip pim spt-threshold infinity [group-list route-map-name]
A route-map policy name can be a maximum of 100 alphanumeric characters.
Modification
This command was introduced.
Chapter I Commands
OL-31626-01