Cisco Nexus 5600 Series Reference page 387

Chapter I Commands
ipv6 pim dr-priority
To configure the designated router (DR) priority that is advertised in IPv6 Protocol Independent
Multicast (PIM6) hello messages, use the ipv6 pim dr-priority command. To reset the DR priority to
the default, use the no form of this command.
Syntax Description
priority
Defaults
The DR priority is 1.
Command Modes
Interface configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
5.0(3)N1(1)
Usage Guidelines
This command requires the Enterprise Services license.
Examples
This example shows how to configure the DR priority on an interface:
switch(config)# interface ethernet 2/2
switch(config-if)# ipv6 pim dr-priority 5
This example shows how to reset the DR priority on an interface to the default:
switch(config)# interface ethernet 2/2
switch(config-if)# no ipv6 pim dr-priority
Related Commands Command
show ipv6 pim
interface
OL-31626-01
ipv6 pim dr-priority priority
no ipv6 pim dr-priority [priority]
Priority value. The range is from 1 to 4294967295. The default is 1.
Modification
This command was introduced.
Description
Displays information about PIM6-enabled interfaces.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
ipv6 pim dr-priority
383