Cisco Nexus 5600 Series Reference page 472

show routing multicast
show routing multicast
To display information about IPv4 multicast routes, use the show routing multicast command.
Syntax Description
ip
ipv4
vrf
vrf-name
all
default
management
source
group
Command Default
None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
6.0(2)N1(1)
Usage Guidelines
This command requires the LAN Base Services license.
Examples
This example shows how to display information about IPv4 multicast routes:
switch(config)# show routing multicast
IP Multicast Routing Table for VRF "default"
(*, 232.0.0.0/8), uptime: 05:11:19, pim ip
Incoming interface: Null, RPF nbr: 0.0.0.0
Outgoing interface list: (count: 0)
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
468
show routing [ip | ipv4] multicast [vrf {vrf-name | all | default | management}]
{{source group} | {group [source]}}
(Optional) Specifies IPv4 routes.
(Optional) Specifies IPv4 routes.
(Optional) Applies to a virtual routing and forwarding (VRF) instance.
VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
Specifies all VRFs.
Specifies the default VRF.
Specifies the management VRF.
Source address for routes.
Group address for routes.
Modification
This command was introduced.
Chapter Show Commands
OL-31626-01