Cisco Nexus 5600 Series Reference page 200

hardware multicast snooping group-limit
hardware multicast snooping group-limit
To configure the number of groups learned through IGMP Snooping, use the hardware multicast
snooping group-limit command.
Syntax Description
limit
Command Default
None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
6.0(2)N1(1)
Usage Guidelines
Before setting a new group-limit, you must either clear the MAC address table or clear the groups already
learned.
The unique OIFL (output interface list) combinations can only be 2000.
Use the vPC type-2 inconsistency to show the configuraitons on vPC peers.
A reload is not neccessary after configuring the group-limit.
This command does not require a license.
Examples
This example shows how to set the maximum number of groups to 500:
switch(config)# hardware multicast snooping group-limit 500
switch(config)#
Related Commands Command
show ip igmp snooping
groups
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
196
hardware multicast snooping group-limit limit
Number of groups learned through IGMP Snooping. The range is from 100 to 8000.
Modification
This command was introduced.
Description
Displays information about the group membership for IGMP snooping.
Chapter H Commands
OL-31626-01