Cisco Nexus 5600 Series Reference page 170

ip igmp robustness-variable
ip igmp robustness-variable
To configure a robustness count that you can tune to reflect expected packet loss on a congested network,
use the ip igmp robustness-variable command. To reset the count to the default, use the no form of this
command.
Syntax Description
count
Command Default
The robustness count is 2.
Command Modes
Interface configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
6.0(2)N1(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to configure a robustness count:
switch(config)# interface ethernet 2/2
switch(config-if)# ip igmp robustness-variable 3
switch(config-if)#
This example shows how to reset a robustness count to the default:
switch(config)# interface ethernet 2/2
switch(config-if)# no ip igmp robustness-variable
switch(config-if)#
Related Commands Command
show ip igmp interface Displays IGMP information about the interface.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
166
ip igmp robustness-variable count
no ip igmp robustness-variable [count]
Robustness count. The range is from 1 to 7. The default is 2.
Modification
This command was introduced.
Description
Chapter I Commands
OL-31626-01