Cisco Nexus 5600 Series Reference page 78

show ip pim neighbor
show ip pim neighbor
To display information about IPv4 Protocol Independent Multicast (PIM) neighbors, use the show ip
pim neighbor command.
Syntax Description
ethernet
slot/port
port-channel
number
sub_if-number
vethernet
veth-id
vlan vlan-id
neighbor-addr
vrf
vrf-name
all
default
management
Command Default
None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
5.0(3)N1(1)
5.0(2)
Usage Guidelines
This command requires the LAN Base Services license.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
MCR-74
show ip pim neighbor {[ethernet slot/port | port-channel channel-number[.sub_if-number] |
vethernet veth-id | vlan vlan-id] | [neighbor-addr]} [vrf {vrf-name | all | default |
management}]
(Optional) Specifies the Ethernet interface and the slot number and port number. The
slot number is from 1 to 255, and the port number is from 1 to 128.
(Optional) Specifies the EtherChannel interface and EtherChannel number. The
range is from 1 to 4096.
(Optional) Subinterface number. The range is from 1 to 4093.
(Optional) Specifies the virtual Ethernet interface. The range is from 1 to 1,048,575.
Specifies the VLAN. The range is from 1 to 4094.
(Optional) IP address of a neighbor.
(Optional) Applies to a virtual routing and forwarding (VRF) instance.
VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
Specifies that all VRF entries be cleared from the IPv4 multicast routing table.
Specifies that the default VRF entry be cleared from the IPv4 multicast routing table.
Specifies that the management VRF entry be cleared from the IPv4 multicast routing
table.
Modification
This command was introduced.
Information on Bidirectional Forwarding Detection (BFD) was added.
Show Commands
OL-31626-01