Cisco Nexus 5600 Series Reference page 439
Nx-os multicast routing command reference
Hide thumbs
Also See for Nexus 5600 Series:
- Configuration manual (378 pages) ,
- Hardware installation manual (100 pages)
Table of Contents
Advertisement
Chapter
Show Commands
show ip pim rp-hash
To display information about the RP-hash values for IPv4 Protocol Independent Multicast (PIM), use the
show ip pim rp-hash command.
Syntax Description
group
vrf
vrf-name
all
default
management
Command Default
None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History
Release
6.0(2)N1(1)
Usage Guidelines
This command requires the LAN Base Services license.
Examples
This example shows how to display information about IPv4 PIM RP-hash values:
switch(config)# show ip pim rp-hash 224.1.1.1
OL-31626-01
show ip pim rp-hash group [vrf {vrf-name | all | default | management}]
Group address for RP lookup.
(Optional) Applies to a virtual routing and forwarding (VRF) instance.
VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
Specifies all VRFs.
Specifies the default VRF.
Specifies the management VRF.
Modification
This command was introduced.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
show ip pim rp-hash
435
Advertisement
Table of Contents
