Cisco Nexus 5600 Series Reference page 321

Nx-os multicast routing command reference
Hide thumbs Also See for Nexus 5600 Series:
Table of Contents

Advertisement

Chapter
I Commands
ip pim auto-rp rp-candidate
To configure an IPv4 Protocol Independent Multicast (PIM) Auto-RP candidate route processor (RP),
use the ip pim auto-rp rp-candidate command. To remove an Auto-RP candidate RP, use the no form
of this command.
Syntax Description
ethernet
slot/port
loopback
if_number
port-channel
number
vlan vlan-id
group-list
prefix
scope ttl
interval
interval
bidir
Command Default
The TTL is 32.
The Announce message interval is 60 seconds
Command Modes
Global configuration mode
VRF configuration mode
Supported User Roles
network-admin
vdc-admin
Command History
Release
6.0(2)N1(1)
OL-31626-01
ip pim auto-rp rp-candidate {ethernet slot/port | loopback if_number | port-channel number |
vlan vlan-id} {group-list prefix} {[scope ttl] | [interval interval] | [bidir]}
no ip pim auto-rp rp-candidate [{ethernet slot/port | loopback if_number | port-channel number
| vlan vlan-id}] [group-list prefix} {[scope ttl] | [interval interval] | [bidir]}
Specifies the Ethernet interface and the slot number and port number. The slot
number is from 1 to 255, and the port number is from 1 to 128.
Specifies the loopback interface. The loopback interface number is from 0 to 1023.
Specifies the EtherChannel interface and EtherChannel number. The range is from 1
to 4096.
Specifies the VLAN interface. The range is from 1 to 4094.
Specifies the group range used for the access list.
(Optional) Specifies a time-to-live (TTL) value for the scope of Auto-RP Announce
messages. The range is from 1 to 255. The default is 32.
Note
See the ip pim border command to explicitly define a router on the edge of
a PIM domain rather than using the scope argument.
(Optional) Specifies an Auto-RP Announce message transmission interval in
seconds. The range is from 1 to 65,535. The default is 60.
(Optional) Specifies that group range is advertised in PIM bidirectional (Bidir)
mode.
Modification
This command was introduced.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
ip pim auto-rp rp-candidate
317

Advertisement

Table of Contents
loading

Table of Contents