Cisco Nexus 5600 Series Reference page 275
Nx-os multicast routing command reference
Hide thumbs
Also See for Nexus 5600 Series:
- Configuration manual (378 pages) ,
- Hardware installation manual (100 pages)
Table of Contents
Advertisement
Chapter
Show Commands
show ip msdp rpf
To display information about the Multicast Source Discovery Protocol (MSDP) next-hop autonomous
system (AS) on the Border Gateway Protocol (BGP) path to a rendezvous point (RP) address, use the
show ip msdp rpf command.
Syntax Description
rp-address
vrf
vrf-name
all
Command Default
None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History
Release
6.0(2)N1(1)
Usage Guidelines
This command requires the LAN Base Services license.
Examples
This example shows how to display information about MSDP reverse path forwarding (RPF) peers:
switch(config)# show ip msdp rpf 192.168.1.10
OL-31626-01
show ip msdp rpf rp-address [vrf {vrf-name all}]
IP address of the RP.
(Optional) Applies to a virtual routing and forwarding (VRF) instance.
VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
Specifies all VRFs.
Modification
This command was introduced.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
show ip msdp rpf
271
Advertisement
Table of Contents
