Cisco Nexus 5600 Series Reference page 402

ipv6 pim sparse-mode
ipv6 pim sparse-mode
To enable IPv6 Protocol Independent Multicast (PIM6) sparse mode on an interface, use the ipv6 pim
sparse-mode command. To disable PIM6 on an interface, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Defaults
Disabled
Command Modes
Interface configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
5.0(3)N1(1)
Usage Guidelines
This command requires the Enterprise Services license.
Examples
This example shows how to enable PIM6 sparse mode on an interface:
switch(config)# interface ethernet 2/2
switch(config-if)# ipv6 pim sparse-mode
This example shows how to disable PIM6 on an interface:
switch(config)# interface ethernet 2/2
switch(config-if)# no ipv6 pim
Related Commands Command
show ipv6 pim
interface
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
398
ipv6 pim sparse-mode
no ipv6 pim [sparse-mode]
Modification
This command was introduced.
Description
Displays information about PIM6-enabled interfaces.
Chapter I Commands
OL-31626-01