Cisco Nexus 5600 Series Reference page 165

Chapter I Commands
ip igmp query-max-response-time
To configure a query maximum response time that is advertised in IGMP queries, use the ip igmp
query-max-response-time command. To reset the response time to the default, use the no form of this
command.
Syntax Description
time
Command Default
The query maximum response time is 10 seconds.
Command Modes
Interface configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
6.0(2)N1(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to configure a query maximum response time:
switch(config)# interface ethernet 2/2
switch(config-if)# ip igmp query-max-response-time 15
switch(config-if)#
This example shows how to reset a query maximum response time to the default:
switch(config)# interface ethernet 2/2
switch(config-if)# no ip igmp query-max-response-time
switch(config-if)#
Related Commands Command
show ip igmp interface Displays IGMP information about the interface.
OL-31626-01
ip igmp query-max-response-time time
no ip igmp query-max-response-time [time]
Query maximum response time in seconds. The range is from 1 to 25. The default is
10.
Modification
This command was introduced.
Description
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
ip igmp query-max-response-time
161