Cisco Nexus 5600 Series Reference page 322
Nx-os multicast routing command reference
Hide thumbs
Also See for Nexus 5600 Series:
- Configuration manual (378 pages) ,
- Hardware installation manual (100 pages)
Table of Contents
Advertisement
ip pim auto-rp rp-candidate
Usage Guidelines
The scope and interval, and bidir keywords can be entered once and in any order.
The ip pim send-rp-announce command is an alternative form of this command.
Using a route map, you can add group ranges that this auto RP candidate-RP can serve.
Note
Use the same configuration guidelines for the route-map auto-rp-range that you used when you create a
route map for static RPS.
This command requires the LAN Base Services license.
Examples
This example shows how to configure a PIM Auto-RP candidate RP:
switch(config)# ip pim auto-rp rp-candidate ethernet 2/1 group-list 239.0.0.0/24
This example shows how to remove a PIM Auto-RP candidate RP:
switch(config)# no ip pim auto-rp rp-candidate ethernet 2/1 group-list 239.0.0.0/24
Related Commands
Command
ip pim
send-rp-announce
show ip pim interface
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
318
Description
Configures a PIM Auto-RP candidate RP.
Displays information about PIM-enabled interfaces.
Chapter
I Commands
OL-31626-01
Advertisement
Table of Contents
