Cisco Nexus 5600 Series Reference page 329

Chapter I Commands
ip pim bsr-candidate
To configure the router as an IPv4 Protocol Independent Multicast (PIM) bootstrap router (BSR)
candidate, use the ip pim bsr-candidate command. To remove a router as a BSR candidate, use the no
form of this command.
Syntax Description
bsr
ethernet
slot/port
loopback
if_number
port-channel
number
vlan vlan-id
hash-len
hash-len
priority
priority
Command Default
The hash mask length is 30.
The BSR priority is 64.
Command Modes
Global configuration mode
VRF configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
6.0(2)N1(1)
Usage Guidelines
The interface specified is used to derive the BSR source IP address used in BSR messages.
This command requires the LAN Base Services license.
OL-31626-01
ip pim [bsr] bsr-candidate {ethernet slot/port | loopback if_number | port-channel number | vlan
vlan-id} [hash-len hash-len] [priority priority]
no ip pim [bsr] bsr-candidate [{ethernet slot/port | loopback if_number | port-channel number |
vlan vlan-id}] [hash-len hash-len] [priority priority]
(Optional) Specifies the BSR protocol RP-distribution configuration.
Specifies the Ethernet interface and the slot number and port number. The slot
number is from 1 to 255, and the port number is from 1 to 128.
Specifies the loopback interface. The loopback interface number is from 0 to 1023.
Specifies the EtherChannel interface and EtherChannel number. The range is from 1
to 4096.
Specifies the VLAN interface. The range is from 1 to 4094.
(Optional) Specifies the hash mask length used in BSR messages. The range is from
0 to 32. The default is 30.
(Optional) Specifies the BSR priority used in BSR messages. The range is from 0 to
255. The default is 64.
Modification
This command was introduced.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
ip pim bsr-candidate
325