Cisco Nexus 5600 Series Reference page 414

show ip mroute
show ip mroute
To display information about IPv4 multicast routes, use the show ip mroute command.
Syntax Description
group
source
summary
software-
forwarded
vrf
vrf-name
all
Command Default
None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
6.0(2)N1(1)
Usage Guidelines
This command requires the LAN Base Services license.
Examples
This example shows how to display information about IPv4 multicast routes:
switch(config)# show ip mroute
IP Multicast Routing Table for VRF "default"
(*, 232.0.0.0/8), uptime: 04:18:55, pim ip
Incoming interface: Null, RPF nbr: 0.0.0.0
Outgoing interface list: (count: 0)
switch(config)#
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
410
show ip mroute {group | {source group} | {group [source]}} [summary [software-forwarded]]
[vrf {vrf-name | all}]
Group address for route.
Source address for route.
(Optional) Displays route counts and packet rates.
(Optional) Displays software-switched route counts only.
(Optional) Applies to a virtual routing and forwarding (VRF) instance.
VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
Specifies all VRFs.
Modification
This command was introduced.
Chapter Show Commands
OL-31626-01