Cisco Nexus 5600 Series Reference page 336

ip pim dr-priority
ip pim dr-priority
To configure the designated router (DR) priority that is advertised in IPv4 Protocol Independent
Multicast (PIM) hello messages, use the ip pim dr-priority command. To reset the DR priority to the
default, use the no form of this command.
Syntax Description
priority
Command Default
The DR priority is 1.
Command Modes
Interface configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
6.0(2)N1(1)
Usage Guidelines
This command requires the LAN Base Services license.
Examples
This example shows how to configure DR priority on an interface:
switch(config)# interface ethernet 2/2
switch(config-if)# ip pim dr-priority 5
This example shows how to reset DR priority on an interface to the default:
switch(config)# interface ethernet 2/2
switch(config-if)# no ip pim dr-priority
Related Commands Command
show ip pim interface
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
332
ip pim dr-priority priority
no ip pim dr-priority [priority]
Priority value. The range is from 1 to 4294967295. The default is 1.
Modification
This command was introduced.
Description
Displays information about PIM-enabled interfaces.
Chapter I Commands
OL-31626-01