Cisco Nexus 5600 Series Reference page 189

Chapter Show Commands
show ip igmp route
To display information about the IGMP-attached group membership, use the show ip igmp route
command.
Syntax Description
source
group
ethernet
slot/port
port-channel
number
sub_if_number
vethernet
veth-id
vlan vlan-id
vrf
vrf-name
all
Command Default
None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
6.0(2)N1(1)
Usage Guidelines
The show ip igmp groups command is an alternative form of this command.
This command does not require a license.
OL-31626-01
show ip igmp route [{source [group]} | {group [source]}] [ethernet slot/port | port-channel
channel-number[.sub_if_number] | vethernet veth-id | vlan vlan-id] [vrf {vrf-name | all}]
Source IP address.
(Optional) Multicast IP address of single group to display.
Specifies the Ethernet interface and the slot number and port number. The slot
number is from 1 to 255, and the port number is from 1 to 128.
Specifies the EtherChannel interface and EtherChannel number. The range is from 1
to 4096.
Subinterface number. The range is from 1 to 4093.
Specifies the virtual Ethernet interface. The range is from 1 to 1,048,575.
Specifies the VLAN. The range is from 1 to 4094.
(Optional) Applies to a virtual routing and forwarding (VRF) instance.
VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
Specifies all VRFs.
Modification
This command was introduced.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
show ip igmp route
185