Cisco Nexus 5600 Series Reference page 452

show ipv6 pim interface
show ipv6 pim interface
To display information about the enabled interfaces for IPv6 Protocol Independent Multicast (PIM6), use
the show ipv6 pim interface command.
Syntax Description
brief
vrf
vrf-name
all
if-type
if-number
Defaults
None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
5.0(3)N1(1)
Usage Guidelines
This command requires the Enterprise Services license.
Examples
This example shows how to display information about PIM6-enabled interfaces:
switch(config)# show ipv6 pim interface
PIM6 Interface Status for VRF "default"
Ethernet2/12, Interface status: protocol-down/link-down/admin-down
IPv6 address: none
PIM6 DR: 0::, DR's priority: ?
PIM6 neighbor count: 0
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
448
show ipv6 pim interface [brief] [vrf {vrf-name | all}]
show ipv6 pim interface if-type if-number
(Optional) Specifies a brief format for display.
(Optional) Applies to a virtual routing and forwarding (VRF) instance.
VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
Specifies all VRFs.
(Optional) Interface type. For more information, use the question mark (?) online
help function.
(Optional) Interface or subinterface number. For more information about the
numbering syntax for your networking device, use the question mark (?) online help
function.
Modification
This command was introduced.
Chapter Show Commands
OL-31626-01