Cisco Nexus 5600 Series Reference page 442

show ip pim vrf
show ip pim vrf
To display information about IPv4 Protocol Independent Multicast (PIM) by virtual routing and
forwarding (VRF) instance, use the show ip pim vrf command.
Syntax Description
vrf-name
all
default
detail
management
Command Default
None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
6.0(2)N1(1)
5.0(2)
Usage Guidelines
This command requires the LAN Base Services license.
Examples
This example shows how to display information about IPv4 PIM by VRF:
switch(config)# show ip pim vrf
PIM Enabled VRF
VRF Name
default
switch(config)#
This example shows how to display the detailed information about IPv4 PIM by VRF:
switch# show ip pim vrf detail
PIM Enabled VRF
VRF Name
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
438
show ip pim vrf [vrf-name | all | default | detail | management]
(Optional) VRF name. The name can be a maximum of 32 alphanumeric characters
and is case sensitive.
(Optional) Specifies all VRFs.
(Optional) Specifies the default VRF.
(Optional) Displays detailed PIM VRF information.
(Optional) Specifies the management VRF.
Modification
This command was introduced.
Information on Bidirectional Forwarding Detection (BFD) was added.
VRF
ID
1
VRF
Table Interface
ID Count
0x00000001 1
Table Interface
Chapter Show Commands
BFD
Enabled
no
BFD
OL-31626-01