Operation Status Control; The Way Of Pump Moving; Preparation - EBARA EV-S20 Instruction Manual

P.5
When an ALARM output is suddenly generated, while the plant unit is operational,
a WARNING signal will be generated to ensure that the plant operation is not
discontinued. This enables the operator to check the pump after the equivalent of
one cycle has been completed.
Be sure to contact EBARA Corporation for details on checking the WARNING and
ALARM setting conditions.

3.2.2 Operation Status Control

The sensor data are displayed on the LCD provided on the controller to facilitate
operation status control and daily inspection.
All WARNING and ALARM signals are displayed on the LCD. For remote
operation and monitoring, the signals are available as individual and group
outputs.

3.3 The way of pump moving

3.3.1 Preparation

Before pump moving, all adjuster feet shall be raised fully at four places.
In case of being not raised fully, pump may be tripped over by obstacle on floor.
EBARA
CORPORATION
PM10U