EBARA EVM Series Operating And Maintenance Manual
Hide thumbs
Also See for EVM Series:
- Operating and maintenance manual (96 pages) ,
- Operating and maintenance manual (107 pages)
Advertisement
Quick Links
Stampato su carta reciclata - Nessun albero è stata abbattuto -
Marchio "Angelo Blu" ⁄ Printed on resycled paper - no trees have
been cutted down - mark "Blue Angel"
EVM
series
..........................................................................................
Operating and maintenance manual ...........................................................................................................2
TRANSLATION FROM ORIGINAL INSTRUCTIONS
EN
Advertisement
Related Manuals for EBARA EVM Series
Summary of Contents for EBARA EVM Series
- Page 1 series ..................TRANSLATION FROM ORIGINAL INSTRUCTIONS Operating and maintenance manual ......................2 Stampato su carta reciclata - Nessun albero è stata abbattuto - Marchio “Angelo Blu” ⁄ Printed on resycled paper - no trees have been cutted down - mark “Blue Angel”...
- Page 2 INSTRUCTION MANUAL REGARDING USE AND MAINTENANCE 2. MANUFACTURER IDENTIFICATION DATA MANUFACTURER DATA INDEX EBARA Pumps Europe S.p.A. INTRODUCTION page 2 Registered office: Via Campo Sportivo, 30 - 38023 Cles (TN), ITALIA MANUFACTURER IDENTIFICATION DATA page 2 Telefono: 0463/660411 - Telefax: 0463/422782...
- Page 3 4.2 IMPORTANT PROTECTIONS AND CAUTIONS 6. TECHNICAL-PRODUCTION CHARACTERISTICS 6.1. DESCRIPTION All products are designed with guards over their moving Your product is a vertical multi-stage non-self-priming pump designed for parts. The manufacturer declines any responsibility in the coupling to standard electric motors. event of damages caused by the removal of said protec- The abbreviations EVMS and EVM identify a wide range of vertical multi- tions.
-
Page 4: Specifications
18.5 160 L Ratings See motor rating plate 180 M This list shows specification of Ebara motors. In case of using other 200 L motors, please see nameplate of motors and check the motor 200 L manufacturer’s specification. The table gives maximum sound emission values for motor-driven pumps. -
Page 5: Installation
8.2 GENERAL INSTALLATION PRECAUTIONS 1. Load direction WARNING! 2. Thrust bearing Remove the delivery and suction caps before hooking 3. Preload spring the product up to the lines a) Use metal or rigid plastic pipes in order to avoid their yielding because of the depression created at suction;... - Page 6 valve at the end of the suction line. In this case it is advisable to use a hose Flange Strain X Strain Y Strain Z Model connected to the pump. EVMS (L)(G) WARNING! Make sure that the sum of the difference in height between EVMS (L)(G) the water and suction port and pressure losses along the EVMS (L)(G)
- Page 7 MOTOR-DRIVEN EVM series Before starting to make electrical connections, make sure that line voltage 11.2 STARTING and frequency match the motor’s values given on the rating plate.
-
Page 8: Troubleshooting
monly, of pump cavitation due to: For further information on equipment collection points, contact your local – excessive difference in height or excessive pressure loss along suction waste disposal authority or the store that you purchased the product from. line, –... - Page 9 DISPLAYED FAULT CAUSE SOLUTION DISPLAYED FAULT CAUSE SOLUTION System System THE PUMP STOPS The difference undersized undersized AFTER WORKING between Increase the differen- Clean the piping, val- FOR BRIEF PERIODS maximum and mi- ce between the two System dirty ves, filters nimum pressure is pressures Pressure...
- Page 10 15. SUPPLIED TECHNICAL DOCUMENTATION Pump model 15.1 STANDARD VOLTAGES SHOWN ON THE PLATE WITH THEIR RE- Maximum EVM32 EVM45 EVM64 SPECTIVE TOLERANCES working pressure [kW] Frequency [Hz] Phase [~] UN [V] ± % 230 ± 10% ≤ 0.55 220 ± 10% 8-12 –...
- Page 11 15.5 POSITIONING OF HOLES FOR FASTENING DOWN FIG. 2 Pump model EVMS1 EVMS3 a) Insufficient immersion; EVMS5 b) Negative slope, air pockets created: EVMS10 c) Tight bend, pressure loss; d) Pipe diameter < pump port diameter, pressure loss EVMS15 EVMS20 [-E-] 15.7 MOTOR-DRIVEN PUMP ID CODE EVM32...
- Page 12 - A - 360° M6=15 Nm M8=18 Nm M10=50 Nm ≥ 5.5 kW ≤ 4.0 kW...
- Page 13 - A - 0.5 mm ≤ AB ≤ +0.5 mm 0.5 mm ≤ CD ≤ +0.5 mm 3 Nm...
- Page 14 - B - IT: Monofase DE: Einphasig PL: Jednofazowa EN: Single phase ES: Monofásico TR: Tek fazlı FR: Monophasé NL: Monofase IT: Monofase con moto protettore DE: Einphasig mit Motorüberlastschutz PL: Jednofazowa z zabezpieczeniem silnika EN: Single phase with motor protector ES: Monofásico con motoprotector TR: Motor koruma cihazıyla tek fazlı FR: Monophasé...
- Page 15 - C - IT: cap. 10.1 EN: chap. 10.1 FR: chap. 10.1 DE: kap. 10.1 ES: cap. 10. NL: hfdst. 10.1 PL: rozdz. 10.1 TR: bol. 10.1 IT: cap. 10.2 EN: chap. 10.2 FR: chap. 10.2 DE: kap. 10.2 ES: cap. 10.2 NL: hfdst. 10.2 PL: rozdz.
- Page 16 - D - EVMS 1 - 3 - 5 - 10 - 15 - 20 ≤ 4 kW M6=15 Nm 3 Nm...
- Page 17 - D - EVMS 1 - 3 - 5 - 10 - 15 - 20 ≥ 5.5 kW M8=18 Nm M10=50 Nm 3 Nm...
- Page 18 - D - EVM 32 - 45 - 64 with bearing 5÷7 Nm...
- Page 19 - D - EVM 32 - 45 - 64 without bearing 5÷7 Nm...
- Page 20 - E - EVMS 1 - 3 - 5 - 10 - 15 - 20 EVM 32 - 45 - 64 IT: 1. Tipo di pompa DE: 1. Pumpentyp PL: 1. Typ pompy 2. Codice per il modello di serie 2.
-
Page 24: Ebara Pumps Europe S.p.a
Cod. 442170999 Rev. D - draft EBARA Pumps Europe S.p.A. UK EBARA Pumps Europe S.p.A. GERMANY EBARA PUMPS SOUTH AFRICA (PTY) LTD Unit A, Park 34 Elisabeth-Selbert-Straße 2 26 Kyalami Boulevard,Kyalami Business Park, Collett Way - Didcot 63110 Rodgau, Germany...