Fault Code; Info Display - Toyota 7BPUE15 Service Manual

Toyota Orderpicker Model 7BPUE 1 5 Service Manual
The battery indicator will always show the mode
with the highest priority that is active. For
example, a n Info Display message will override
a battery state of charge message.

Fault Code

All five LEDs flash in series to identify the fault
code. Each series (code) has two digits. If more
than one code is present ("stacked codes"),
there are rapid flashes between codes.
There is no limit to the number of stacked
codes, but only the highest priority codes will be
Top LED blinking
2nd LED from top
blinking
(If optional sidegate
with interlocks is
attached) 3rd LED from
top blinking
I
4th LED from top
blinking
Bottom LED blinking
Battery Discharge Indicator (BDI)
On the BDI display, each LED represents a
different level. See Figure 6-2.
00700-CL222-05, 1 5 March 2005
I
you request motion.
Steering wheel was not turned (initialized)
after key switch turned ON.
Carriage reached lift limit (if equipped).
Battery charge is too low.
Section 6. Codes and Tests
Operator Display Messages
displayed. Once these codes are resolved, the
next highest codes are displayed until they are
resolved.
Each code is explained later in this section. See
"Operator Display Fault Codes" on page 6-15.
Each LED represents a different condition. The
table on the following page shows the cause and
how to clear each display.
Pull out EPO switch and reset kt
switch.
1. Return controls to neutral.
2. Step on deadman pedal.
Turn steering wheel.
Lower sidegate.
Press lift limit bypass switch to
continue lifting.
Use fullv-charged battery.
Full
3/4
Recharge
Figure Battery State-of-Char
Full
2nd
3rd
4th
Bottom
g e