Switches (General) - Toyota 7BPUE15 Service Manual

Toyota Orderpicker Model 7BPUE 15 Service Manual
Electrical Components

Switches (General)

Click here for information on updates switches
Refer to the electrical schematic in the
Appendix to identify the electrical circuit
location of the switch.
Click here for information on updated Switch
There are two deadman switches (S2 and S23).
Replacement
Use extreme care whenever the truck is
jacked up. Keep hands and feet clear
from the vehicle while jacking the truck.
After the truck is jacked, place solid
blocks beneath it to support it.
rely on the jack alone to support the
truck. See "Jacking Safety" on
2-1 1.
page
7-83.
Figure
1. Raise operator platform high enough (at
least 3 feet [9 1.44 cm]) to access bottom of
2. Block operator platform with a 4 in. x 4 in.
(100 x 100 mm) block.
3. Turn key switch OFF and disconnect
battery connector.
of deadman pedal post.
00700-CL222-05, 1 5 March 2005
5.
While holding the two return springs in
place, lift pedal straight up.
6. Remove the two screws mounting the
7. Disconnect wires from switch(es). Note
location and mark if necessary for
recondition later.
8. Replace defective switch(es). See
Figure 7-83.
9. Reconnect wires.
10. Align washers with holes.
11. While holding the two return springs in
place, install pedal assembly. See
Figure 7-83.
12. Install washer and lock n u t on bottom of
13. Connect power and test truck operation
before returning to service.
DO NOT
Emergency Power
The emergency power off (EPO) switch is S 2 1.
Removal
1. Disconnect battery, turn key switch OFF
and remove key.
2. Remove operator console cover. See
"Operator Console Cover" on page 7- 12.
3. Disconnect wires EPO 1 and 2 from back
of EPO switch. See Figure 7-84.
7-84.
Figure
Section 7. Component Procedures
Switches (General)
Off
Switch
E P O
Switch a n d Key Switch locations