Load Wheels - Toyota 7BPUE15 Service Manual

Section 7. Component Procedures

Load Wheels

Load Wheels
Use extreme care whenever the truck is
jacked up. Keep hands and feet clear of
from the vehicle while jacking the truck.
After the truck is jacked, place solid
blocks beneath it to support it.
rely on the jack alone to support the
truck. See "Jacking Safety" on
2-1 1.
page
7- 146. load Wheel
Figure
1. Raise operator platform approximately 1
ft. from the floor. Place a 4 x 4 inch (10 x
10 cm) block across top of baselegs
underneath platform.
2. Turn key switch OFF and disconnect
battery.
3 . Jack up baseleg high enough to clear load
wheel from under baseleg. Block under
4. Remove snap ring from axle. See
Figure 7- 146.
5. Drive out axle. The load wheel will fall out
of baseleg. See Figure 7- 146.
6. Replace load wheel assembly.
7. Drive axle back through wheel and
8. Install snap ring.
9. Remove blocks.
Toyota Orderpicker Model 7BPUE 15 Service Manual
DO NOT
00700-CL222-05, 1 5 March 2005
Mast Section