Lift Motor; Pump-To-Motor Connection; Lift Motor Connections; Bottom Of Pump - Toyota 7BPUE15 Service Manual

Toyota Orderpicker Model 7BPUE 15 Service Manual
Electrical Components
Lift
Motor
Removal
1. Turn key switch OFF and disconnect
battery.
2. Remove tractor covers. See "Tractor
Covers" on page 7- 1 1.
N : In the next steps you will need a 5 gallon
OTE
19 liter) capacity container.
3. Drain hydraulic fluid. See "Hydraulic
Fluid" on page 7-60.
4. Disconnect hoses from pump.
5. Use two-wrench method to disconnect
power cables from lift motor. See
Figure 7-57.
Figure 7-57.

lift Motor Connections

6. Remove the four bolts that hold motor to
bracket. See Figure 7-57.
7. Lift out motor and pump assembly.
N : Rest the motor on the bracket lip.
OTE
8. Remove pump from motor. See
Figure 7-58.
00700-CL222-05, 1 5 March 2005
Section 7. Component Procedures
Figure 7 -5 8 .

Pump-to-Motor Connection

1. Add anti-seize compound (P/N
00590-04836-7 1) to spline shaft of pump
before mounting to motor. See
Figure 7-59.
2. Mount pump to motor. See Figure 7-58.
3. Install four bolts to fasten the motor to its
bracket on the tractor frame.
Figure 7 -5 9 .

Bottom of Pump

4. Connect power cables. See Figure 7-57
5. Attach hoses.
6. Replace hydraulic filter. See Figure 7-57.
7. Insert drain plug in drain hose and fill the
hydraulic reservoir with new fluid. See
"Lubrication Specification Chart" on
page A-2.
8. Connect battery and turn key switch ON.
9. Test lift functions.
10. Install tractor and top covers.

Lift Motor