Flow Control Valve; Flow Control Valve Location; Replacing Flow Control Valve - Toyota 7BPUE15 Service Manual

Toyota Orderpicker Model 7BPUE 15 Service Manual
Hydraulic Components

Flow Control Valve

Figure 7- 108. Flow Control Valve Location
Replace
1. Lift and block carriage enough to reach
valve housing block.
2. Turn key switch OFF and disconnect the
battery.
3. Remove hydraulic tubing. See
Figure 7- 108.
4. Remove fitting. See Figure 7-108.
5.
Pull out flow control valve.
6. Place the new valve in the housing.
Figure 7- 109. Replacing Flow Control Valve
N : Follow the directional arrow on the flow
O TE
control valve to install it correctly. It
should be pointing out of the housing in
the direction of flow. See Figure 7- 109.
00700-CL222-05, 1 5 March 2005
Section 7. Component Procedures
7. Place the hydraulic fitting in the valve
housing block with the O-ring end first
and tighten.
Install hydraulic tubing.
Remove blocks and bleed the hydraulic
system. See "Bleeding the Hydraulic
System" on page 7-64.
Connect power and test lift function befc
returning truck to service.
Flow Control Valve