Section 7. Component Procedures
Circuit Cards (General)
Figure 7-80. Steer/Tractor Manager Circuit Card
Figure 7-8 1
Steer Power Head Circuit Cart
:
Use proper precautions against
electrostatic discharge. See "Static
2-9.
Safety" on page
N
: Before removing a good carriage
O TE
manager, use the Flashware Program to
clear the memory. See "Clear Primary
Memory" on page 10-6.
Removal
1. Turn key switch OFF and disconnect
battery.
Toyota Orderpicker Model 7BPUE 15 Service Manual
2. Remove appropriate cover(s). See "Tractor
Covers" on page 7- 1 1.
3. If removing a circuit card from tractor,
remove circuit card cover.
4. Disconnect all connectors on this circuit
card.
5.
Remove all screws holding circuit card to
frame.
Figure 7-82. Carriage Manager in Operator Console
Installation
1. Install new circuit card with the screws
you removed earlier.
2. Attach connectors to circuit card.
3. Connect battery connector and turn key
4. If installing a circuit card in the tractor,
install circuit card cover.
5.
Install appropriate cover(s).
6. Connect power and test operation before
returning truck to service.
00700-CL222-05, 1 5 March 2005
Electrical Components