Toyota 7BPUE15 Service Manual page 404

Subject: Switch Replacement
.
Installation Instructions
1. Remove the connector from the switch assembly.
2. Remove and discard the old switch/housing assembly. See Figure 1.
3. Install new switch assembly (item 1). See Figure 2.
4. For connector Type A, perform Steps 4.a through 4.d. For connector Type B, proceed to
Step 5.
a. Connect adapter harness (item 2) connector PX to the connector that was originally
plugged into the old switch. See Figure 3.
b. Secure the truck harness to the adapter harness. Use the notches to hold the ty-wrap
(item 3) in place. See Figure 4.
c. Slide the shrink tubing (item 4) over the connectors. See Figure 5.
Figure 2
Figure 3
Figure 4
Figure 5
Page 2 of 3