Toyota Orderpicker Model 7BPUE 15 Service Manual
bolts for the pre-drilled holes. Connect to
the filter card.
Tractor Sensor Assembly, lnstalled
Figure
5. Install the bumper plate.
6. Apply the bumper decal to the bumper
plate a s shown in Figure 8-8.
7. Use additional cable straps a s necessary.
Figure
Bumper Decal, location
00700-CL222-05, 1 5 March 2 0 0 5
Kit Components for Steps
Figure
Speed Encoder
N
: To perform step 1, we recommend using
O T E
a n impact gun.
1. Remove the nut off the shaft on top of the
drive motor.
2. Install motor/encoder stud
See Figure 8-9.
3 . Install the O-rings (P/N 00590-45949-71)
in the grooves on the motor/encoder stud.
See Figure 8-9.
4. Install the encoder mounting plate (P/N
00590-45855-7 1) on top of the brake with
the following hardware in the order listed.
See Figure 8-9.
Section 8. Wire Guidance
Install Kit Components
2-4