Auto/Manual Switch; Steer Encoder, Installed; Auto/Manual Switch Cable - Toyota 7BPUE15 Service Manual

Toyota Orderpicker Model 7BPUE 15 Service Manual
Installation
1. Clean the encoder shaft. Apply retaining
compound (Loctite 609) to the encoder
shaft.
2. Install the steer encoder kit (P/N
00590-45880-7 1) on the shaft.
3. Install the encoder cover and the two
mounting screws.
4. Secure the encoder to the motor with the
two screws provided with the steer
encoder. See Figure 8- 13.
5. Route the cable from the encoder down the
side of the motor and connect to cable
JH7.
8- 13.

Steer Encoder, Installed

Figure
6. Route that cable along the existing wiring
to PT6 on the steer/tractor manager.
7. Use cable ties as necessary.
8- 14.
Cutting the Auto/Manual Switch Detenf
Figure
00700-CL222-05, 1 5 March 2005
Section 8. Wire Guidance
1. Remove the operator console cover.
2. Remove the bezel.
3. From the backside of the bezel, use a hot
knife to cut out the detent for the
4. Place the rocker switch orange-side-up in
the bezel.
5. Install the connector housing (P/N
1-0 12-339/004) on the auto/manual
switch cable (P/N 00590-45865-7 1). See
Figure 8- 1 5.
6. Connect the cable to the auto/manual
switch. See Figure 8-15. Then connect to
the carriage manager.
7. Place the auto/manual switch decal (P/N
00590-45783-7 1) on the front side of the
bezel. See Figure 8- 16.
Install Kit Components