Lift Chains, Three-Stage; Center Cylinder Chain; Side Cylinder Chains - Toyota 7BPUE15 Service Manual

Toyota Orderpicker Model 7BPUE 15 Service Manual
Mast Section

Lift Chains, Three-Stage

Use extreme care whenever the truck is
jacked up. Never block the truck
between the mast and the floor. Keep
hands and feet clear from vehicle while
jacking the truck. After the truck is
jacked, place solid blocks beneath it to
support it. DO NOT rely on the jack
alone to support the truck. See "Jacking
2- 1 1.
Safety" on page

Center Cylinder Chain

Replace
1. Attach suitable hoist and lift carriage
approximately 3 feet (.9 m) and block.
2. Disconnect chain from chain anchor and
feed out of truck.
3. Replace as necessary.
4. Feed chain over pulley and connect in
chain anchor.
5.
Remove block and hoist.
6. Connect power and test lift function before
returning the truck to service.
Figure 7- 137. lower Anchor Block
00700-CL222-05, 1 5 March 2005
Section 7. Component Procedures

Side Cylinder Chains

Replace
1. Lift carriage enough to block between
carriage and inner mast.
2. Add block.
3. Disconnect chain from chain anchors and
feed off pulley. See Figure 7- 137 and
Figure 7- 138.
4. Replace chain as necessary. See
Figure 7- 139.
5.
Feed chain over pulley and connect in
chain anchors. See Figure 7-137 and
Figure 7- 138.
Figure 7- 138. Upper Chain Anchor and Pulley
Figure 7- 139. Master Link of Lift Chain
Chains, Three-Stage
Lift